Download
Share
Print this page
  1. Manuals
  2. Brands
  3. ETI Manuals
  4. Dehumidifier
  5. NETCOM ADH
  6. Assembly replacement procedure

ETI NETCOM ADH Assembly Replacement Procedure

Automatic air dehydrator, compressor replacement procedure
Hide thumbs Also See for NETCOM ADH:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
MODEL ADH
NETCOM
®
AUTOMATIC AIR DEHYDRATOR WITH ETHERNET
®
ADH
NETCOM™ AUTOMATIC AIR DEHYDRATOR
COMPRESSOR ASSEMBLY
REPLACEMENT PROCEDURE
Replacement Kit Part Number 24085
Document Part Number 24098
South Bend, Indiana USA
|
networketi.com
1
ADH INSTRUCTION MANUAL | PART NO.
24098
REV
B

Advertisement

loading
Need help?

Need help?

Do you have a question about the NETCOM ADH and is the answer not in the manual?

Questions and answers

Related Manuals for ETI NETCOM ADH

Summary of Contents for ETI NETCOM ADH

  • Page 1 MODEL ADH NETCOM ® AUTOMATIC AIR DEHYDRATOR WITH ETHERNET ® NETCOM™ AUTOMATIC AIR DEHYDRATOR COMPRESSOR ASSEMBLY REPLACEMENT PROCEDURE Replacement Kit Part Number 24085 Document Part Number 24098 South Bend, Indiana USA networketi.com ADH INSTRUCTION MANUAL | PART NO. 24098...

  • Page 2: Safety Information And Warnings

    SAFETY INFORMATION AND WARNINGS Abnormal Odor or Smoke Rack Mounting In the event of smoke or a burning or Before and after rack mounting the abnormal odor, immediately interrupt ADH NETCOM, ensure that the rack power to the ADH NETCOM with the is stable.

  • Page 3: Inventory List

    ADH NETCOM COMPRESSOR ASSEMBLY REPLACEMENT PROCEDURE This procedure addresses the removal and replacement of the Compressor Assembly in an ADH NETCOM Automatic Air Dehydrator. The first section addresses the replacement of the Compressor Assembly in the AC and DC models. The second section, starting on Original 2 Hole Mount page 6, addresses the replacement of the Compressor Assembly in the ADH...
  • Page 4 COMPRESSOR ASSEMBLY REMOVAL AND REPLACEMENT To replace the compressor (23216) in either an ADH NETCOM with AC power or an ADH NETCOM with Redundant DC power, “Captive” end screws perform the steps below. Refer to Figure 1. cannot be removed. To replace the compressor (23216) in an ADH NETCOM AC NEMA, proceed to page Figure 2.
  • Page 5 The mounting hole “footprint” of the Connect the new compressor green replacement compressor assembly power connector to the same place from mounting bracket most likely does not which the original compressor power match the mounting hole footprint of connector was removed in step 3, then the original bracket.
  • Page 6 To replace the compressor (23216) in an Remove and retain the four mounting ADH NETCOM AC NEMA, perform the steps screws from the four corners of the below. protective front cover, then slowly lift the front cover, carefully flip it over, Shut machine power...
  • Page 7 Using a 5/16” nut driver, loosen and the two screws and the slotted remove the nuts and lock washers mounting holes used on the original securing the existing compressor mounting bracket. mounting bracket to the chassis. Retain the mounting hardware for re- Reconnect the air hose which was use.
  • Page 8 ETI, Inc. The ETI logo, We Manage Heat, and ADH are registered trademarks ETI, Inc. NETCOM is a trademark of ETI, Inc. Copyright © 2012 ETI, Inc. All rights reserved.