Things To Check Before You Call For Service - Culligan Sulfur-Cleer Fiberglass Owner's Manual

Things to Check
Before You Call
for Service
20
01023492 F 06/19
If you unexpectedly experience changes in your water, make these simple checks before calling your
Culligan deal er. One of the following conditions may be the reason for your interruption of service.
Important
If any of the following conditions is found, the water filter should be man u al ly reconditioned according to
instructions on page 18 after you have corrected the problem.
Power Supply
Check your power supply cord. Is it plugged fully into the electric outlet? Be certain that the outlet
is not controlled by a wall switch which has been turned off. Plug in the transformer then reset
conditioner to proper time of day.
Blown Fuse
Check the house fuse or circuit breaker panel. Replace a blown-out fuse or reset an open circuit breaker.
Power Failure
Any interruption in your power supply or time change—such as daylight savings—will disrupt your filter's
reconditioning schedule by causing the timer to run off schedule. Reset the timer to the proper time of day.
Bypass Valves
Check to see if they are in the proper position. Cul-Flo-Valv
"Service" position (see page
opened and that the bypass valve is closed.
No Water
If you aren't getting any water flow at all, make sure your water supply is work ing. Open a tap ahead of
the filter (outside tap) to see if you have any water pressure. If you have water pressure, check the bypass
valve. If it is in the Service position, put it into the bypass and call your Culligan dealer for service.
Increased Usage
Guests, family additions, new water-using appliances, etc., all will result in more water usage and will
require more capacity from your filter. You can re pro gram your recondtioning schedule by following
the directions on page 17. Call your Culligan dealer for advice and save a service call.
19). If hand valves are used, see that inlet and outlet valve are
Bypass, if used, should be in the
®