ESI Solution 3 Instructions Manual

Articulating arm and keyboard platform

Table of Contents

Download this manual

Solution 3

ARTICULATING ARM and

KEYBOARD PLATFORM

Model SOLUTION 3

SOLUTION 3 Rev A 4/17

SOLUTION 3

INSTALLATION AND USE

Table of Contents

Need help?

Do you have a question about the Solution 3 and is the answer not in the manual?

Page 1 Solution 3 ARTICULATING ARM and KEYBOARD PLATFORM Model SOLUTION 3 SOLUTION 3 Rev A 4/17 SOLUTION 3 INSTALLATION AND USE...
Page 2 Contact your supplier if any operates to your satisfaction. Solution 3 combines the AA360 articulating arm with the PL215 keyboard platform. In this instruction booklet, installation of the two products will be explained in sequence, beginning with the AA360.
Page 3 SOLUTION 3 STEP 2: Attach Track • Drill " pilot holes through all 11 holes in the track. — Drill the holes " deep or Attach Through Rear Eight Holes Only 1" deep, depending on which wood screws will be used.
Page 4 SOLUTION 3 The PL215 keyboard platform features a swivel mouse pad that can be attached to either the left or right side. PL215 PARTS PROVIDED Keyboard Platform (1) Palm Rest (2) 1 Each for Keying and Mousing Flathead Screw (4)
Page 5 SOLUTION 3 STEP 6: Attach Keyboard Platform • Attach the keyboard platform to the keyboard arm and track assembly using the four flathead screws and flange nuts. — Be sure the flange on the nuts is facing upward. IMPORTANT: The flange nuts must be fully tightened to ensure the nuts are locked.
Page 6 SOLUTION 3 STEP 7: Manage Cables • Adhere cord clips to the underside of the keyboard platform as needed to organize the keyboard and mouse cables. Cord Clip OPERATION To Raise or Lower Keyboard: • Tip the platform up to unlock.

Aa360Pl215