Rangemaster 90 Gas User Manual page 30

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
21. To Adjust an Oven Door Catch Keep
Open oven door, slacken off the locknut at the base of the
keep, and screw in or out as required until the required fit is
obtained. Retighten the locking nut.
22. To Change an Oven Door Seal
Open the oven door. The seal is held in place by small hooks
on the rear face. At the corner, pull the seal diagonally away
from the door centre until that hook is released. Proceed to
the next hook and release it in a similar way, and so on. Use
force if the hooks are stiff, as the old seal will be discarded.
When fitting the new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door, and
proceed round the door, snapping in each hook in turn.
23. To Remove Right-Hand Oven Inner Back
Disconnect from electricity supply.
Open right-hand door and remove shelves. Remove screws
and washers, four on the left over as shown in the diagram
and two on the right oven and securing the inner back of the
oven.
Carefully lift away the inner back. Reassemble in reverse order
making sure that the screws and washers are fully tightened.
24. To Remove the Fan Oven Element
Disconnect from electricity supply.
Remove the oven inner back (see 23).
Element fixing screws
ArtNo.321-0005 Fan oven element
Remove the two screws from the top of the element and the
one from the bottom of the element inside the oven. Lift the
element out carefully, disconnecting the terminals connected
to the element (noting their positions). If it is not possible to
disconnect the leads in this way, pull the cooker forward to
gain access to the rear, remove the screws securing the electric
cover to the back sheet, remove the cover and disconnect the
terminals from the rear.
Fit the new element and reassemble in reverse order. Check
the operation of the oven.
25. To Remove Oven Fan
Disconnect from electricity supply.
Pull the cooker forward to gain access to the rear. Remove
the screws securing the electric cover to the back sheet and
remove the cover. Disconnect the three terminals connected
to the fan noting their position. Remove the oven inner
back (see 23). Hold the fan blade and remove the centre nut
(left-hand thread) two brass washers, fan blade and Circlip.
Unscrew the fan retaining nuts and washers (three off each)
and lift the fan away from the rear of the cooker. Fit the new
fan and reassemble in reverse order. Check the operation of
the oven.
26. To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted to alter
the angle of the door. Loosen the bottom hinge fixing screws
and use the notch and a flat bladed screwdriver to move the
position of the hinge to set the hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
28