Rangemaster 90 Gas User Manual page 24

Check the appliance is electrically safe and gas sound when you have finished.
Grip under the fascia panel and lift the front of the cooker
slightly.
Carefully push the cooker backwards out of the base pack.
Push the cooker close to its final position, leaving just enough
space to get behind it.
Do not use the door handles or control knobs to
manoeuvre the cooker.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust the
height of the rear of the cooker use the levelling tool supplied
to turn the adjusting nuts at the front bottom corners of the
cooker.
Adjust the height of the front roller to level the cooker. Turn
clockwise to raise the cooker and anticlockwise to lower.
When you are satisfied with the height and level raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the floor. Screw the front
roller adjuster anticlockwise to raise the front roller so that
the front of the cooker is supported on the feet, not the front
roller, to prevent accidental movement of the cooker.
Leave the levelling tool on the adjuster with the handle of the
tool facing the rear of the cooker, so that the customer can
use it if they wish to move the cooker.
Fitting a stability bracket
A stability bracket or chain (not supplied by with the cooker)
should be fitted when the cooker is connected to a flexible
gas supply.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
INSTALLATION
1. Place the cooker in its intended position and level it.
2. Draw a pencil line 70mm from the front edge of the
levelling feet.
3. Mark the centre line for the bracket by measuring
550mm from the left-hand side of the cooker.
4. Lower the front roller and move the cooker forward.
5. Measure back from the pencil line 500mm to locate
the front edge of the bracket. Position the bracket so
that it is away from centreline of the cooker to reduce
the possibility that it will trap the electrical connection
cable or gas hose. Fix the bracket to the floor.
6. Measure the height from floor level to engagement
edge in back of cooker. Add 3mm to this dimension and
assemble the stability bracket to this height. (i.e. from
floor level to underside of the top member) and ensure
the bracket does not foul the oven burner assembly.
Gas Connection
Must be in accordance with the relevant standards. A hose is
not supplied by with the cooker. Hoses may be purchased at
most builders' merchants.
The Gas supply needs to terminate with a down facing
bayonet. The rear cover boxes limit the position of the supply
point.
Because the height of the cooker can be adjusted and
each connection is different it is difficult to give precise
dimensions. Ideally the house supply bayonet should be in
the shaded area shown in the diagram. Although a 900mm
hose can be used, a 1250mm hose will allow slightly more
flexibility in the positioning of the bayonet and make moving
the cooker easier. The hose should be fitted so that both inlet
and outlet connections are vertical so that the hose hangs
downwards.
22