Rangemaster 90 Gas User Manual page 23

Check the appliance is electrically safe and gas sound when you have finished.
A clearance of 130mm is required if the cooker is near a
corner of the kitchen to allow the oven doors to open. The
actual opening of the doors is slightly less but this allows for
some protection of your hand as you open the door.
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly
in front of the place it is to be installed (unless it will not
fit through a door in its outer packaging). Cut the banding
straps and lift the cardboard box off the cooker, leaving
the cooker standing on the base packaging. See the loose
unpacking sheet.
Moving the Cooker
On no account try and move the cooker while it is plugged
into the electricity supply.
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker. Ensure
that the floor covering is firmly fixed, or removed to prevent it
being disturbed when moving the cooker around.
To help you, there are two levelling rollers at the back, and
two screw-down levelling feet at the front. You will need the
levelling tool.
From the back tilt the cooker forward and remove the rear
half of the polystyrene base pack. Repeat from the front and
remove the front half of the poly base.
INSTALLATION
Lowering the Two Rear Rollers
Fit the levelling tool on the rectangular adjuster as shown
below.
Make 10 complete (360°) turns clockwise. (This means turning
and removing the levelling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Unfold the rear edge of pack base tray. Open the grill door
and right-hand oven door so that you can get a good grip on
the bottom of the fascia panel as you move the oven:
21