Lubrication Of The Gas Taps; Connecting The Power Supply Cable; Feeder Cable Section - Fisher & Paykel OR90SDBGFX3 Installation Instructions Manual

Hide thumbs Also See for OR90SDBGFX3:

Table of Contents

Burners

(*) Power calculated with inner crown operating

(#) Power calculated with inner and outer crowns operating

Lubrication of the Gas Taps

A qualified technician must lubricate the gas taps.

• All intervention regarding installation maintenance and conversion of the appliance must be

• The manufacturer declines any liability if these correct parts are not used.

This cooker must be connected to the electricity supply only by an authorised person.

This cooker must be connected to electrical supply using H05RR-F insulated cable 220-240V~ 3 x 1,5 mm

To connect the Power Supply Cable to the Cooker, it is necessary to:

1. Unhook the terminal board cover by inserting a screwdriver into the two hooks 'A' (Fig. 14).

2. Unscrew the screw 'D' and open completely the cable clamp 'E' (Fig. 15).

3. Connect the phase, neutral and earth wires to terminal board 'G' according to the diagrams in Fig. 15.

4. Strain the feeder cable and block it with cable clamp 'E' (by screwing screw 'D').

5. Close the terminal block cover (check the two hooks 'A' are correctly hooked).

https://producthelp.fisherpaykel.com/eu/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFX3/User_Guide_OR90SDBGFX...

Nominal Power [KW]

fulfilled with original factory parts.

Reduced Power [KW]

LPG

Natural Gas

G30 - 28-30 mbar

G20 - 20 mbar

G31 - 37 mbar

Injector Dia.

[1/100 mm]

(no. 2 outer)

Updated: Thu, 26 Mar 2020 03:34:19 GMT

cable.

Table of Contents