Table of Contents
Advertisement
Split Cable Bushings
Eighteen split cable bushings are shipped with the GranDSLAM chassis. These
bushings keep the rear cables in place and protect them from being damaged by
the cable management brackets.
Procedure
To install the split cable bushings:
When you have correctly installed the split cable bushing, it points toward the
center of the chassis with the large diameter ring flush against the outside of the
cable management bracket, holding the cable in place.
8820-A2-GN20-30
1. Dress the cable of connector 1 to the right and through the slotted hole that is
second from the top (top hole is not used) of the cable management bracket.
NOTES:
— Cables from connectors 1 to 8: dress to the right.
— Cables from connectors 10 to 18: dress to the left.
2. Taking one of the split cable bushings, open the bushing and slip it over the
cable on the outside of the cable management bracket.
3. Slide and snap the bushing into the slotted hole of the cable management
bracket.
4. Repeat this procedure for each of the remaining cables.
CAUTION:
Do not block the air vents on the side of the chassis with the cables.
Side View
Split Bushing
Shipped Loose
(Field Installed)
Cable
Management
Bracket
Air Vents
March 2001
Rear View
Customer's Network Cables
18
17
16
15
14
13
12
11
10
9 8 7 6 5 4 3 2 1
Ground
Lug
3. Cabling
00-16164a-03
3-5
Advertisement
Table of Contents
