Paradyne Hotwire 8820 GranDSLAM Series Installation Manual page 33

Procedure
To remove the multislot filler plate:
Procedure
To adjust the multislot filler plate to cover empty slots:
8820-A2-GN20-30
1. Remove the screws fastening the filler
plate to the chassis.
2. Lift the filler plate away from the chassis.
CAUTION:
Breakaway may cause sharp edges and burrs. Use due care.
1. Count the number of DSL cards that you will be installing.
— If you are installing fewer
than 8 cards, go to
— If you are installing cards
in Slots 1 through 8 or
10 through 17, remove the
appropriate multislot filler
plate (use tabs provided).
2. From the side of the multislot
filler plate without the EMI
gaskets, break away as many
panels as needed.
NOTE:
Be sure to break off panels
from the side of the filler plate
opposite the EMI gaskets. The
edge with the the EMI gaskets
is needed to create a good EMI
seal with the card in the slot to
the left of the filler plate.
March 2001
Slot 1
SY ST
EM
OK
Alm
Tes t
ETH ERN
ET
TX
RX
Co ll
DS L PO RT
1
2
3
4
DSL
POWER ENTRY MODULE
LEFT UNIT: LINE A
RIGHT UNIT: LINE B
WARNING!
POWER MUST BE DISCONNECTED
BEFORE REMOVING OR INSTALLING
Step 2.
Break at Score
Multislot Filler Plate
Rear View
2. Installation
Screws Slot 18
POWER
ALARMS
A B
Fan Major Minor
SYS TEM
OK
Alm
Tes t
ETH ERN
ET
TX
RX
Col l
MCP
POWER ENTRY MODULE CLOCK SERIAL AC
A
LEFT UNIT: LINE A MCC ALARM
RIGHT UNIT: LINE B 2 4 LAN/WAN SLOT
6 8 A
10 12
14 16
18
AT THE SOURCE
THIS PWR ENTRY MODULE WARNING! POWER MUST BE DISCONNECTED
BEFORE REMOVING OR INSTALLING AT THE SOURCE
THIS PWR ENTRY MODULE
B SERIAL
CLOCK ALARM 1
SMCM 3 5 7
9 B 11
13 15
17
Screws
00-16260a-02
Caution
Label
EMI
Gaskets
99-16261-01
2-19