Table of Contents
Advertisement
Installing the MCP Card
Use a flat-blade or Phillips screwdriver to install the MCP card into Slot 9.
Procedure
To install the MCP card:
8820-A2-GN20-30
1. Remove the single filler plate
from Slot 9 and store it for future
use.
2. Position the MCP card vertically
and insert it into the top and
bottom card guides of Slot 9.
3. Slide the MCP card into the slot.
Gently but firmly push the card
until it properly seats in its
mating connectors on the
backplane.
CAUTION:
Do not force the MCP card
into the slot. If it does not seat
properly, remove the card and
reinstall it. If it still does not
seat properly, call for service.
4. The MCP card will now perform a power-on self-test. All of the LEDs turn ON
and OFF briefly. When the self-test is completed successfully, the SYSTEM
OK LED will turn ON. Make sure the OK SYSTEM indicator on the MCP
faceplate is ON (blinking green).
5. Secure the MCP card by tightening the top and bottom screws on the
faceplate. This is required to ensure proper pressure on the EMI gaskets and
to maintain proper air flow.
March 2001
2. Installation
MCP Card
Slot 9
POWER
ALARM S
A
B
Fan
Major Minor
SY STE
M
OK
Alm
Tes t
ETH ERN
ET
TX
RX
Col l
MCP
POWER ENTRY MODULE
LEFT UNIT: LINE A
POWER ENTRY MODULE
CLOCK
SERIAL
RIGHT UNIT: LINE B
AC
LEFT UNIT: LINE A
A
MCC
ALARM
RIGHT UNIT: LINE B
2
LAN/WAN SLOT
4
6
8
A
10
12
14
16
18
WARNING!
POWER MUST BE DISCONNECTED
AT THE SOURCE
BEFORE REMOVING OR INSTALLING
WARNING!
THIS PWR ENTRY MODULE
POWER MUST BE DISCONNECTED
BEFORE REMOVING OR INSTALLING
AT THE SOURCE
THIS PWR ENTRY MODULE
B
SERIAL
ALARM
CLOCK
1
3
SMCM
5
7
9
B
11
13
15
17
00-16265a-02
2-17
Advertisement
Table of Contents
