Table of Contents
Advertisement
2. Installation
Installing DSL Cards into Slots 1–6 and 10–17
If you are installing only one DSL card in the GranDSLAM chassis, it is
recommended that you use Slot 1 first, and then proceed to fill the other slots in
ascending numerical order (2–8 and 10–18). When you get to Slots 8 and 18, see
Installing DSL Cards into Slots 8 and 18
installing additional DSL cards, you must ensure that a filler plate covers the
remaining empty slots.
Filler Plate Removal, Adjustment and Reinstallation
The GranDSLAM chassis comes with the following filler plates installed:
T
T
T
T
If you are installing DSL cards in Slots 1 through 8, or 11 through 17, you will need
to remove a multislot filler plate. After installing the card, you will need to adjust the
remaining portion of the filler plate according to the number of cards being
installed, and then reinstall the filler plate. The following table of procedures will
serve as a reference.
Filler Plates for the GranDSLAM Chassis
2-18
Two single, 0.8-inch wide, EMI-gasketed filler plates (for Slots 9 and 18)
Two single, 1-inch wide, EMI-gasketed filler plates (for Slots A and B)
Two receptacle filler plates (for Slots 8 and 17)
Two multislot filler plates (for Slots 1 through 7 and 10 through 16)
If You Are
Populating . . .
Then . . .
Slots 1–7
1. Remove the multislot filler plate from the chassis.
and 10–16
2. Break away as many panels as needed.
3. Reinstall the filler plate to cover remaining empty slots.
4. Make sure the attached receptacle covers the broken edge.
5. Make sure the EMI gasket is on the side of the filler panel that is
opposite the receptacle.
Slots A–B,
Remove the single EMI-gasketed filler plate. Store for future use.
9 and 18
Slots 8 and 17
Remove the single filler plate with receptacle and install
EMI-gasketed filler plate.
March 2001
on page 2-21. Whenever you are
8820-A2-GN20-30
Advertisement
Table of Contents
