8820-A2-GN20-30
2. Insert the bottom edge of the locking pivot bracket inside the lower edge of the
rear panel cutout.
Rear Panel
Receptacle on Backplane
Cutout
3. Align the two connectors.
4. Rotate the connector until it is fully seated.
5. Tighten the captive screw on the top of the cable's connector to secure it to the
insert mounted on the rear cover.
6. Repeat this procedure for the remaining connectors.
March 2001
Locking Pivot
Bracket
99-16163d-01
Rotate
99-16163e-01
Tighten Screw
99-16163f-01
3. Cabling
3-3