Table of Contents
Advertisement
Changing the Setback Position of the Mounting Brackets
The setback position of the mounting brackets may be changed from the shipped
1-inch setback position to the flush, 3-inch, or 5-inch setback positions by
removing the mounting brackets' three screws, repositioning the mounting
brackets, then reinstalling the three screws.
Procedure
8820-A2-GN20-30
1. Remove the screws (three on each side) that hold the mounting brackets to
the chassis.
2. Reposition the brackets for the desired setback (flush, 1-inch, 3-inch, or
5-inch). (Refer to procedures for reversing brackets if installing in a 23-inch
rack in
Positioning the Mounting Brackets for 19-Inch EIA-Type or 23-Inch
NEBs-Type Racks
on page 2-6.)
3. Replace and tighten the three screws on each side to attach the brackets in
the setback position.
4. Follow the procedures for installing the chassis in a 19- or 23-inch rack in
Installation into a 19-Inch or 23-Inch Rack
March 2001
2. Installation
on page 2-8.
2-7
Advertisement
Table of Contents
