Troubleshooting; Troubleshooting Table - Siemens HB74AS 0 Series Instruction Manual

Installing
When installing the glass, check that the phrase "right above"
on the bottom left-hand side is upside down.
Insert the interior glass, tilting it upwards and then inserting it
1.
downwards (figure A).
$
Refit the clamps on the bottom left and right hand side
2.
(figure B). To do this, hook the clamps in the upper part of
the support and press into place (figure C).
%

Troubleshooting

Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.

Troubleshooting table

Fault Possible cause Solution/advice
The oven does The fuse has
not work. blown.
Power cut
Power cut
The symbol
0
lights up on the
display with
some zeros.
The oven does There is dust in
not work. the contacts.
The oven door The oven door
does not open. has been
locked by the
The symbol
H
self-cleaning
lights up on the
function
display panel.
The display The appliance
has been
shows "‰ .
automatically
turned off.
&
Check the condition of the
fuse/circuit breaker in the
fuse box.
Check that the light in the
kitchen and other
household appliances are
working.
Set the time once again.
Turn the control knob
several times in both
directions.
Wait until the oven has
cooled and the
H
turns off.
.
x
Turn the function control
knob to the zero setting.
Refit the entire door base (figure D).
3.
First, screw the two lower bolts into place then the two upper
4.
bolts (figure E).
'
Hanging the oven door.
5.
Once the glass panels have been correctly fitted, the oven is
ready to use.
Error messages
When the indicator displays an error message with
the sensor. The message will disappear. The set time
0
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
Error message Possible cause Solution/advice
"‹‚‚
"‚‹‡
"‚‚†
ã=
Risk of electrical discharge and the resulting shock.!
Incorrect repairs can be dangerous. Repairs can only be
symbol
carried out by qualified personnel from the Technical
Assistance Service.
(
A sensor has Press all the sensors one
been pressed by one. Check if a sensor is
for too long or stuck, covered or dirty
has got stuck.
The door lock
Press the
has been
can now begin
activated with
programming again.
the door open.
The The door oven is locked
temperature and heating has stopped.
inside the oven Wait until the oven has
is too high.
cooled. Press the
and reset the time.
, press
"
sensor. You
0
0 sensor
13