Side Access; Front Access- Access To Power Bus - Allen-Bradley 1512B User Manual

Side Access

A side bus access cover is located on each side of the controller.
1. Remove the hardware from the appropriate side bus access cover (see
Figure 7).
2. Remove the side bus access cover.
3. Once the side bus access cover is removed, you will see the three power bus
bars and the ground bus (see
Figure 9 - Side Bus Access Cover Removed
Front Access– Access to Power Bus
ATTENTION: To avoid shock hazards, lock out incoming power (refer to
Lock-out Procedure on page 57 of Chapter
Verify with a hot stick or appropriate voltage measuring device that all circuits
are voltage free. Failure to do so may result in severe burns, injury or death.
1. Complete the Power Lock-out Procedure (refer to
Procedure on page 57 of Chapter
and the power bus.
2. Open the doors and remove the hinge pins.
Rockwell Automation Publication 1500-UM055H-EN-P - December 2014
Installation – Standard Enclosure
Figure 9).
5) before working on the equipment.
Power Lock-out
5) for both medium voltage power cells
Chapter 2
Power
19