Table of Contents
Advertisement
Getting Started
STEP 3. Install the Network Analyzer Modules
e. In the case of Configurable Test Set, there are several options of divider
combinations. Refer to
Installation" on page 14
f. Tighten the top mounting screw (see callout 7 in
bottom mounting screw (located below the injector/ejector handle) on
the module(s) using a Phillips #1 torque drive set to 4 in-lbs (0.45 N.m).
Figure 1-10 Alignment Plate Installation
"Configurable Test Set (M9377A and M9378A)
for the full combinations.
20
Figure
1-3) and the
Advertisement
Table of Contents
