Keysight M9485A Startup Manual page 19

Getting Started
STEP 3. Install the Network Analyzer Modules
Standard Receiver or Direct Access Receiver
# of
77A
&
78A
pair
5
5
5
5
Table 1-6 Possible Configuration for Combination of Configurable Test Set (6 Sets) and
Standard Receiver or Direct Access Receiver
# of
77A
&
78A
pair
6
If you are using other chassis than Keysight's, you may need a routing for trigger path of
NOTE
the chassis. Refer to the M9485A FAQ page on the Keysight.com for more information
(http://www.keysight.com/find/m9485A)
2-Way Divider and 4-Way Divider Installation
Slot #
76A 7 8 9
1 78A 77A 77A
1 78A 77A 77A
1 78A 77A 77A
1 78A 77A 76A
Slot #
76A 7 8 9
0 78A 77A 77A
a. Upon placing all the modules into the chassis, if you are using dividers,
fasten the modules only after alignment plate is installed.
on page 20 shows the installation of the M9376-60016 4-Way
alignment plate on the modules.
b. Only after the alignment plate is installed, the black plate cover should
be removed. 2-port module have the option of using M9376-60014
2-Way alignment plate.
c. Next, fasten the M9376-62006 4-way divider by ensuring that the
SMP-SMP adapter are fit well through the alignment plate, as shown in
Figure 1-11 on page
the M9376-62004 2-way divider.Confirm that the screws on 2/4 way
divider are fasten firmly.
d. In the case of Standard Receivers M9376A only, 4-port modules requires
3 of the 4-way divider to be connected. Similarly, 8-port modules require
6 of the 4-way divider and 12-port modules require 9 of the 4-way
divider.
10 11 12 13
78A 78A 77A 77A
78A 78A 77A 77A
78A 76A 77A 78A
78A 77A 77A 78A
10 11 12 13
78A 78A 77A 77A
21. 2-port modules have the option of using 3 of
19
14 15 16 17
78A 78A 77A 76A
78A 76A 77A 78A
78A 77A 77A 78A
78A 77A 77A 78A
14 15 16 17
78A 78A 77A 77A
Figure 1-10
18
18
78A