Installation Wireless Inlinemeter; Powermanager; Configuration; Settings Delivery State / Factory Settings - Kentix AlarmManager-BASIC User Manual

Hide thumbs Also See for AlarmManager-BASIC:
Table of Contents

Advertisement

10.5.2.

Installation Wireless InlineMeter

The installation is done in following steps:
No
Interrupt power supply. For the duration of the electrical work, the power supply for the entire work area must be
1
disconnected by switching off the corresponding fuses.
Plug the radio InlineMeter between the supply voltage and the load. Please make sure that the plug is completely
2
connected.
3
Restore power.
10.5.3.

PowerManager

To install the PowerManager, simply attach the supplied mounting bracket to the wall or ceiling and attach the
PowerManager. Then establish a network connection to a PoE switch.
Make sure that the maximum distance between PowerManager and the SmartMeters or InlineMeters must not
exceed 30 meters, otherwise the wireless connection is not guaranteed.
10.5.4.

Configuration

For configuration purposes, a web server is integrated in the PowerManager in order to be able to configure and
operate the device via the network using a web browser.
Connection with PC:
Connect the LAN jack of the PowerManager to a PoE-enabled switch using a LAN
cable. Also establish a network connection between your PC and this switch.

Set the IP address of your PC to eg "192.168.100.123".

10.5.4.1. Settings delivery state / factory settings

Power supply:
PoE (Power over Ethernet).
Default IP-Adress:
192.168.100.224
Subnet-Mask:
255.255.255.0
User / password:
admin / password
IMPORTANT! - Reset to factory settings
For security reasons, resetting the PowerManager is only possible immediately after the system has been
started for a period of 1 minute.
You can restart the PowerManager by briefly unplugging and reconnecting the connected network cable.
Then wait about 30 seconds until the device is ready for operation (green LED active) and press the
button.
Press and hold the button for 15 seconds until the reset process is confirmed by a long tone.
The device is reset to factory settings and restarts. After approx. 30 seconds, the PowerManager can be
reached again via the standard settings.
Page
95
Description
(07-2018, subject to change)
kentix.com

Advertisement

Table of Contents
loading

Related Products for Kentix AlarmManager-BASIC

This manual is also suitable for:

Alarmmanager-pro

Table of Contents