Table of Contents
Advertisement
5.9.2.
Manage alarm zones
Each device connected to the AlarmManager (MultiSensors, cameras, server, IO-Modules) can be allocated to
an alarm zone, creating a separation into different logical areas. Each zone can be armed or disarmed
independently and alert.
For configuration, add alarm zones to a building in the "System" area by clicking on the „+". The mask for
adding new alarm zones appears.
Existing alarm zones can also be edited by clicking the gear next to the name of the zone.
After creating the alarm zone, a device can be assigned to this zone via its sensor settings.
Alarm behaviour
IMPORTANT!
Also with multiple sensors in one zone an alarm of the type „Armed-Active" can only be reported once for
every zone. After alarming the alarm repetition is activated. If a continuous alarming is desired, the automatic
quitting of alarms can be activated in the advanced settings.
With this an armed-active alarm will automatically be quit after the configured time.
Alarm zone settings and signaling
Define here the behavior of the AlarmManager when alarms occur. For active alarms, each alarm zone can be
assigned a timer profile for timed activation / deactivation. The arming delay allows you to set a time between
arming and first alarm activation.
The acoustic feedback (buzzers of AlarmManager and sensors) and the behavior of the LEDs can be activated
or deactivated as required. Exempted from this setting is the CO alarm. Depending on the set buzzer time, an
acoustic feedback is always triggered on all buzzers.
Page
18
(07-2018, subject to change)
kentix.com
Advertisement
Table of Contents
