Table of Contents
Advertisement
6.6. MultiSensor-LAN
In contrast to the MultiSensor RF with radio interface, the MultiSensor LAN can also be operated in stand-alone
mode without AlarmManager. For configuration in stand-alone mode, a web server is integrated via which you
can configure and operate the device via the network with a web browser. The SNMP software interface makes
integration into network management systems easy.
Connection via PC:
Connect the LAN jack of the MultiSensor-LAN with a PoE enabled switch. Also connect
your PC to the same switch. Set the IP address of your PC to e.g. „192.168.100.123".
6.6.1. Default settings / Factory defaults
Voltage supply:
PoE (Power over Ethernet). Operation with external power supply possible.
Default IP-address:
192.168.100.223
Subnet mask:
255.255.255.0
User / password:
admin / password
IMPORTANT! - Reset to factory defaults
In the case that the IP-address or login data are lost it is possible to reset the MultiSensor-LAN to factory
defaults. For this there is a RESET button which can be reached via a hole on the back of the device. Reboot
the device and wait until the internal status LED turns green againt.
Now press the reset button for about 10 seconds, until there is an acoustic feedback. After about 30 seconds
the MultiSensor will reboot and can then be reached again using the default settings.
6.6.2. Software function MultiSensor-LAN
In the following, the stand-alone functionality of the integrated web server is described. For the described
functionality no AlarmManager is required. When operating the MultiSensor-LAN with the AlarmManager-PRO,
the AlarmManager controls the configuration and monitoring functions.
Page
29
(07-2018, subject to change)
kentix.com
Advertisement
Table of Contents
