Table of Contents
Advertisement
9. Smart Access - Introduction
Thank you very much for choosing to purchase a KENTIX access solution based on KENTIX DoorLock.
9.1.
Product features
The KENTIX AccessPoint is the central component of the access solution. Door knobs, door handles, wall
readers and cabinet locks are connected via radio here. The AccessPoint is connected to the network via a
PoE-enabled switch.
The web interface can then be used to change the basic settings, such as IP data, as well as the configuration
of user data and profiles.
A description of the configuration can be found later in this guide.
Kentix Smart Access offers a fully networked locking solution that can combine up to 15,000 doors into one
system.
The smallest unit is the Kentix Wireless Knob in combination with a mechanical lock cylinder or wireless door
handle, wall scanner or cabinet lock. The components can either be operated wirelessly with the Kentix
AccessPoint, or Offline (easy setup and management via the programming card set).
The Kentix AccessPoint implements networking of the devices with each other.
9.2.
Application areas
• Industry and trade
• Banks
• Authorities and hospitals
• Telecommunication
• Chambers and practices
• Energy and water supplier
9.3.
Safety instructions
The installation of the AccessPoint and all DoorLock components must be carried out by a qualified person.
In the event of a power failure, the settings of the AccessPoints are not lost.
To bridge longer downtime, use a suitable UPS.
Installation
To ensure the safety and integrity of the operator as well as the correct operation of the KENTIX DoorLock
components, the installation must be carried out by a competent person. In addition, the relevant regulations
must be adhered to.
Environment
The installation site must be selected so that the KENTIX AccessPoint and all associated cables are not
affected by the following environmental influences:
Dust, moisture, excessive heat; direct sunlight; heat sources; devices that generate strong electromagnetic
fields; liquids or corrosive chemicals.
Observe the ambient conditions given in the technical data.
Degree of protection
When installing an AccessPoint, certain degrees of protection must be guaranteed. Observe the relevant
regulations for installations in specific environments such as industrial or residential and commercial buildings.
Page
52
(07-2018, subject to change)
kentix.com
Advertisement
Table of Contents
