Maintenance Actions; Ec-200/Ec-210 Maintenance Actions - Barco Event Master E2 Series User Manual

No. Maintenance action
1 Check battery valid date.
13.4 EC-30 maintenance actions
No preventive action is needed on this device.
13.5 EC-50 maintenance actions
No preventive action is needed on this device.

13.6 EC-200/EC-210 maintenance actions

MAINTENANCE TYPE C (perform every year)
The yearly maintenance actions, listed below, may be performed by the user in accordance with the
procedures described in the EC-200/EC-210 Maintenance chapter*.
No. Maintenance action
1 Check battery valid date.
2 Remove dust accumulation
Preventive maintenance actions
Remarks
If the date is older than 4 years,
replace battery as a preventative
measure.
See Image 16-15 for the location
of the system battery.
Note: When a new battery is
installed, the user needs to place
a sticker with the date on the
motherboard mount that indicates
when the battery was last
replaced. The absence of sticker
means the battery has never
been replaced. In this case the S/
N sticker can be used for the
reference date.
Remarks
If the date is older than 4 years,
replace battery as a preventative
measure.
Note: When a new battery is
installed, the user need to place a
sticker with the date in the unit
(on the rear of the chassis, near
the Motherboard) that indicates
when the battery was last
replaced. The absence of sticker
means the battery has never
been replaced. In this case the S/
N sticker can be used for the
reference date.
Remove dust accumulation from
the CPU fan on the motherboard
with a few short bursts of
compressed air.
R5905948 /12 Event Master Devices 381