Updating Firmware - Barco Event Master E2 Series User Manual

Updating firmware

8.1 Upgrading firmware using the USB port........................................................................................ 302
About this chapter
This chapter provides a detailed procedure for upgrading Event Master series processor software (firmware).
The Event Master series processor provides an option for upgrading firmware using the USB port on the front
panel.
Another solution is available to upgrade the Event Master series processor with the built-in web
interface. For details on the upgrade procedure via the Setting Menu in the Event Master Toolset
Software (EM GUI), please refer to chapter "Settings Menu > Web App area > Tools > Manage
Software", page 264
In the event the Event Master series processor gets into a state in which it constantly reboots after a
software upgrade, press and hold the SEL and ESC keys simultaneously until the front panel shows
the choice of performing a factory reset or continuing. Performing a factory reset will allow the Event
Master series processor to boot normally.
R5905948 /12 Event Master Devices
8
301