Return To Factory Default; Communication Setup - Barco Event Master E2 Series User Manual

System Setup
4. On the Status Menu:
• System1 is the default value displayed as System Name if this is the first start of the unit. This name can
be changed in the configuration page of the GUI.
• Ensure the Event Master series processor is connected on the local network. For more information about
setting up the Event Master processor to be controlled on a local network, refer to "Communication setup",
page 276.

7.4 Return to factory default

General
Prior to performing any setup procedures, it is recommended that you perform a factory reset — in order to
reset all input, output and source mappings to their default values.
Particularly for customers in the events and rental marketplace, this procedure guarantees that any previous
input setups and memory registers (e. g., those that may have been programmed by other users) are
completely cleared from system memory.
If you are continuing an event (for example, day two of a three-day event), you do not need to
perform a factory reset. However, if you do elect to perform a factory reset, ensure that you have
backed up your system. for details, please refer to the procedure "Backing up the system", page
279.
Prerequisite
• Ensure that you are familiar with the Reset Menu. For details on all menus, please refer to chapter
"Restoring Factory Default Settings", page 99.
Restoring factory settings
To restore all default settings to the Event Master series processor, use the following procedure:
1. Select Factory Reset from the front-panel Setup Menu.
The Factory Reset Menu appears.
2. Select Factory Reset to reset the entire system to its factory default values. Remember that all data will be
lost.
or
Select Factory Reset, Save IP to reset the entire system to its factory default values, but retains the IP
address of the unit.
A prompt appears, asking if you want to clear all configurations.
3. Press SEL.
The system turns off, then it reboots.

7.5 Communication setup

General
In this procedure, you will set up communication between the Event Master series processor and the local
network.
Prerequisite
• Ensure that you are familiar with the Ethernet Menu. For details on this menu, please refer to chapter
"System menu > Ethernet", page 93.
276 R5905948 /12 Event Master Devices