Removal Of Appliance From Shipping Materials - Quadra-Fire 4300 Series Installation Manual

F. Removal of Appliance from Shipping
Materials
WARNING
Fire Risk.
Inspect appliance and components for
damage. Damaged parts may impair
safe operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components.
Report damaged parts to dealer.
Millennium:
1. Remove box and 2x4 structural boards being careful
not to damage product.
2. Using 7/16 inch socket or wrench remove one bolt
located inside front part of appliance (Figure 7.1).
3. Moving to the back of the appliance and using 7/16
inch socket or wrench remove two bolts (Figure 7.1).
4. Carefully pull appliance off of pallet and put in desired
location following Hearth Pad on
Clearance to Combustibles on
Figure 7.1
February 19, 2020
page 13 and
page 15.
3
7037-801B
Step Top:
1. Remove box and 2x4 structural boards being careful
not to damage product.
2. Using 7/16 inch socket or wrench, remove and discard
the two lag bolts from mounting brackets; one on
each side, that is attaching the appliance to the pallet
(Figure 7.2).
3. Carefully pull appliance off of pallet and lay appliance
on back side on a protective surface.
4. Reference Appliance Set-Up on
removal system, leg or pedestal attachment options.
5. After appliance is completely assembled place in
desired location following Hearth Pad on
Clearance to Combustibles on
Figure 7.2
page 21 for ash
page 14
page 15.
Lag bolt Lag bolt
Mounting
bracket
and
7