Appliance Set-Up; Pedestal Assembly & Ars Installation - Quadra-Fire 4300 Series Installation Manual

5

Appliance Set-Up

A. Pedestal Assembly & ARS Installation
NOTE: The Ash Removal System, must be installed first
before installing the pedestal.
Begin installing the ARS System:
1. Remove leg mount brackets packaged inside of firebox
and discard.
2. Remove the 2 bricks in the front most part of the firebox
(Figure 21.1).
3. Lay appliance on its back on a protective pad or pallet
(Figure 21.2).
4. Remove heat shield by loosening the four bolts using
3/8 open end wrench (Figure 21.2).
5. Remove 8 nuts that hold the cover plate on using a
7/16 socket wrench; discard cover plate (Figure 21.2).
WARNING!
CHECK GASKET!
• Verify that the gasket is present and that the glossy
side is away from firebox bottom.
• It is important that the gasket is put in correctly for
sealing capabilities.
6. Remove knock out from bottom of firebox by using a
hammer (Figure 21.2).
7. Install ash door assembly by sliding the rod at an angle
into the slot on the left side (Figure 21.3).
8. Slide the ash door over the 8 screws protruding from
the bottom of the appliance. Secure with nuts and
washers using 7/16 socket wrench (Figure 21.3).
9. Install ARS latch by sliding latch assembly over 2
threaded studs protruding from the bottom on the left
hand side of the appliance. Secure by using two nuts
use 7/16 socket wrench (Figure 21.3).
10. Add knob to handle rod (Figure 22.2 on
11. Using two bolts and two flange nuts to secure ARS
channel using 3/8 open end wrench and 7/16 socket
wrench (Figure 22.3 on
WARNING
Fire Risk. Do NOT operate before fully
assembling components.
Burning your appliance without a pedestal or
leg kit attached:
• Will void your warranty.
• May result in property damage or
personal injury.
February 19, 2020
page 22).
page 22).
Figure 21.1 installation and then re-install
3
Loosen
X4
Figure 21.2
Figure 21.3
7037-801B
Remove
and discard
2
2
Remove 2 bricks for
4
6
Remove
X8
Gasket
X
Remove
& discard
4
5 Knock out
& discard
Ash Door
Assembly
8 threaded
studs
Slot to slide rod of Ash
Door Assembly through
21