Setting The Inverter; Dc Battery Type; For Iss 1Play Tl M; For Iss 1Play Tl - Ingeteam INGECON SUN STORAGE 1Play TL Use And Settings

4 Setting the inverter

This chapter describes how to configure the inverter settings when the ISS 1Play has been wired to the LG
RESU battery.
To do so, once all the previous steps have been completed, the following steps must be followed:
1) Make sure that the battery circuit breaker is in OFF or TRIP position.
2) Move the circuit breaker to ON position to turn the battery pack on.
3) Make sure that the battery pack is successfully initialized. To do so, the status indicator on the front
should flash in blue.
4) After a few seconds the inverter should get powered.

4.1 DC Battery type

Please be careful to choose the right battery type when you set up the configuration in
your inverter. The battery or inverter manufacturers have no responsibility on the
damages caused due to incorrect configurations. For instance, if you select "Lead-acid"
as a battery type in the inverter configuration and the battery being used is "Lithium-ion",
the battery might get damaged or experience performance degradation.
It is required to set the DC Battery type: LG RESU 3.3/6.5/10

4.1.1 For ISS 1Play TL M

This must be done using the web interface of the inverter. To perform any configuration change, the required
installer access must be entered on the web. When the permission is given, go to:
CONFIGURATION > ADVANCED SETTIGNS > TYPE OF BATTERY > LG RESU 3.3/6.5/10
Confirm the desired selection by pressing the "Write" button. A message to confirm the modification will pop
up.

4.1.2 For ISS 1Play TL

This can be done using the "Ingecon Sun Manager" software package (downloadable on www.ingeteam.com)
or through the display:
Using Ingecon Sun Manager:
Settings → 1-.DC BATTERY TYPE: Type of Battery > Lithium: LG Resu LV Series 48V.
Click on the "Send" button. A screen informing that the configuration was successfully saved must appear
when the settings are correctly applied to the inverter.
Using the Display:
To perform any configuration change through the display, the required installer password must be entered on:
The password is indicated on the "Installation and Operation Manual", on the chapter dedicated to
configuration.
Technical Guide
Figure 1: DC Battery selection on Ingecon Sun Manager.
MAIN MENU > CONFIGURATION > ENTER PASSWORD
22/04/2020
INGECON SUN STORAGE 1Play
8/10