Plug The Y-Axis Endstop Cable Connector; Add New Zip Ties; This Part Replacement Is Now Complete! - MakerBot Replicator 2X How To Replace

The Z­axis endstop is the one located directly behind the threaded Z­axis rod behind you build
platform.
19. Plug the Y­axis endstop cable connector into the Y­Axis endstop.
The Y­axis endstop is the one located in the back left corner of your Replicator 2X. To get the
cable connector there, route it behind the three Z­axis rods and under the metal cable clip next
to the endstop.
20. Add new zip ties to the plastic clips.
There are three zip tie holder clips in the top of the the Replicator 2X's frame. To attach cables
to a zip tie holder clip, do the following:
Take a thin zip tie and bend a centimeter or two of the end into a sharp, fish­hook shape. Poke
the end of the hook through the hole in the zip tie holder. Tighten the zip tie around the cable or
cables enough that it holds them still, but not so much that it could harm the cables.
The zip tie holder clip at the upper right side should hold the X­axis sections of both the motor
and endstop cables. The zip tie holder clip at the back towards the right side should hold the Y
and Z­axis sections of the endstop cables. The zip tie holder clip at the back by the left corner
should hold only the Y­axis section of the endstop cable.
This part replacement is now complete! Return the right side panel to the Replicator 2X, plug in
your bot, and try out your new endstop cable.