Commissioning; Initial Setup - ABB TC16-20 Series Product Manual

7

Commissioning

7.1

Initial setup

A menu for initial installation is displayed directly after the following situations:
The first electrical connection.
■
– Electrical connection: see chapter 6.3 "Electrical connection" on page 16.
First mounting of the operating control.
■
– Mounting of the operating control: see chapter 6.2 "Mounting / dismantling" on page 14.
After a reset.
■
– Reset: see chapter 8.4.4 "Expert Menu ‒ Factory defaults" on page 32.
All entries can also be made later in the settings.
If no floor sensor is connected, an error message is displayed when selecting the application for
"floor control" and "Room control / floor limitation". In this case, select the "Room control"
application and confirm it.
Fig. 10: Initial setup
Product manual 2CKA001473B9664 │ 01.03.2020
Commissioning
│17