Mounting / Dismantling - ABB TC16-20 Series Product Manual

6.2

Mounting / dismantling

Caution! The device can sustain damage when coming into contact with
hard objects!
The plastic parts of the device are sensitive.
–
–
The flush-mounted insert must only be installed in flush-mounted wall boxes according to DIN
49073-1, Part 1, or suitable surface-mounted housings.
To install the device, perform the following steps:
Fig. 3: Wall mounting: pulling off the attachment
Fig. 4: Device in as-delivered state: pulling off the
attachment
Product manual 2CKA001473B9664 │ 01.03.2020
Pull the attachment off only with your hands.
Do not lever parts off with screwdrivers or similar hard objects.
Connection, installation / mounting
– If the device is already mounted or
assembled, pull the attachment off
the flush-mounted insert with the aid
of the cover frame.
– If the device is in its as-delivered
state, pull the attachment off the
flush-mounted insert with your hands.
– Pull the attachment off only with
your hands!
– Do not lever parts off with
screwdrivers or similar hard
objects. This will damage the
device.
– When pulling off, first the
resistance of the spring clamps
must be overcome.
│14