Table of Contents
Advertisement
Operation and Control
Replace guard place
If you want to use the façade cutter with the star-type wheel dresser, the star-type
serrated wheel dresser or the carbide cutter with indexable inserts, a special guard
plate (ID No. 57463) must be fitted to reduce dust.
• Remove the guard plate (3), see above.
• Remove all washers (2) and replace with the four spacer sleeves supplied.
• Position the guard plate for the star-type wheel dresser, the star-type serrated wheel
dresser or the carbide cutter with indexable inserts.
• Screw in and tighten the four hex socket cap screws (4).
Connect dust extractor
Figure 5
• Danger!
Fine and toxic dust is harmful.
► If materials that produce harmful dusts are cut (e.g. quartz sand, lead-containing
paint pigments, etc.), a suitable dust extractor (e.g. BAIER BSS 506 special dust
extractor) must be connected to the façade cutter.
• Remove the cap (2) on the socket (1).
• Check the dust extractor is working properly and then push the dust extractor hose
(3) firmly onto the socket (1).
• The socket (1) is designed for the suction hose of BAIER's BSS 506 special dust
extractor.
• Please note!
Greater effort may be required to push on the suction hose in cold ambient tempera-
tures.
(Figure 4, page 18)
(Figures 5 and 6)
Figure 6
19
Advertisement
Table of Contents
