ResMed ApneaLink Air Patient Instructions page 5

Step 3: Apply the finger probe
- Slide your finger into the probe. The wire should run
along the top of your hand as shown.
- Your finger tip should be visible at the end of the probe.
Step 4: Turn on the device and go to sleep
- When setup is complete, your device should look like this:
- When you are ready for bed and have your device prepared
as instructed in Steps 1, 2, and 3, press and hold the power
button in the center of the device for about 3 seconds or
until the light turns on.
- Be sure that all lights next to the accessories plugged in
are green.
*Note: DO NOT touch the power button again if the light dims or turns
off as this is normal on some models.