Yamaha TMAX ABS Series Owner's Manual page 42

Instrument and control functions
The odometer shows the total distance
traveled by the vehicle.
Tripmeters:
1
2
3
"TRIP1" and "TRIP2" show the distance
4
traveled since they were last set to ze-
ro.
To reset a tripmeter, use the select
5
switch to select the information display
page that contains the tripmeter you
6
want to reset. Push the "
select switch for one second so that the
tripmeter flashes, and then push the
7
" " side of the select switch again for
one second while the tripmeter is flash-
ing.
8
TIP

The odometer will lock at 999999.
9

The tripmeters will reset and con-
tinue counting after 9999.9 is
reached.
10
11
When approximately 3.0 L (0.79 US gal,
12
0.66 Imp.gal) of fuel remains in the fuel
tank, the last segment of the fuel meter
starts flashing. In addition, the informa-
13
tion display will automatically change to
the fuel reserve tripmeter mode "F-
TRIP" and start counting the distance
14
traveled from that point.
In this case, push the select switch to
switch the display in the following order:
F-TRIP
If you do not reset the fuel reserve trip-
meter manually, it will reset automati-
cally after refueling and traveling 5 km
(3 mi).
TIP
You cannot enter setting mode (page
5-10) while "F-TRIP" is on.
Estimated traveling range:
" side of the
The estimated distance that can be
traveled with the remaining fuel under
the current riding conditions is shown.
Ambient temperature:
This shows the ambient temperature
from –9 C to 50 C in 1 C increments.
The temperature displayed may vary
from the actual ambient temperature.
TIP



5-9
Display–1
Display–3 F-TRIP
–9 C will be displayed even if the
detected temperature is lower.
50 C will be displayed even if the
detected temperature is higher.
The accuracy of the temperature
reading may be affected when rid-
ing under 20 km/h (12 mi/h) or
when stopped at traffic signals and
Display–2