Instrument And Control Functions; Handlebar Switches - Yamaha TMAX ABS Series Owner's Manual

Instrument and control functions

Handlebar switches

Left
1
1
2
3
2
4
5
3
6
7
4
1. Select switch "
2. Menu switch "MENU"
3. Dimmer/Pass switch "
5
4. Cruise control setting switch "RES+/SET–"
5. Turn signal switch "
6. Horn switch "
6
7. Cruise control power switch "
Right
7
8
9
10
1. Engine stop switch "
2. Mode switch "MODE"
3. Hazard switch "
11
4. Power on/Starter switch "ON/
Dimmer/Pass switch "
12
Set this switch to "
beam and to "
13
To flash the high beam, press the
switch down to "PASS" while the head-
lights are on low beam.
14
EAU77490
/ "
/ /PASS"
/ "
"
"
1
2
3
4
/ "
"
"
EAU85660
/ /PASS"
" for the high
" for the low beam.
TIP

When the switch is set to low
beam, the inner two headlights
come on.

When the switch is set to high
beam, all four headlights come on.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Power on/Starter switch "ON/ "
With the smart key turned on and within
range, press this switch to turn on the
power to the vehicle. Then with the sid-
estand up and while applying the front
or rear brake, push this switch to crank
the engine with the starter. See page
7-2 for starting instructions prior to
starting the engine.
Hazard switch " "
With the vehicle power is on or in park-
ing mode, use this switch to turn on the
5-1
EAU66040
/ "
". When re-
EAU66030
"
EAU77450
/ "
" before starting
" to
EAU77291
EAU79601