Setting The Heat Output; Selecting The Temperature; Setting The Running Time; Swivel Function - Silvercrest SHLF 2000 B2 Operating Instructions Manual

BB&3(B%ERRN 6HLWH 'LHQVWDJ  0DL    
4. In order to switch back to standby mode,
press the standby button
After a few seconds stopping time, the
device switches into standby mode.
NOTE: the device requires electricity in this
state.
5. In order to completely switch off the de-
vice, set the main switch|9 to 0.

6.2 Setting the heat output

• Press Mode|21 repeatedly until the de-
sired heat setting is shown on the dis-
play|10:
Low heat output: device oper-
ates at 1,000 watt
High heat output: device oper-
ates at 2,000 watt
Automatic mode: the device au-
tomatically adapts the heat out-
put to the room temperature.
Frost protection: the device only
switches on at 6 °C ambient
temperature.

6.3 Selecting the temperature

• The button +|20 allows you to increase
the desired temperature up to 38 °C, while
the button -|22 allows you to reduce the
desired temperature down to 6|°C.
The selected desired temperature is shown
on the display|34.
The room temperature is measured by the
temperature sensor|8 and shown on the dis-
play|33.
The device switches off automatically once
the room temperature has reached the de-
sired temperature. If the room temperature
falls below the desired temperature, the de-
vice automatically switches back on again.

6.4 Setting the running time

|23 again.
The device has a timer|24, with which you
can set the desired running time. The run-
ning time can be set at between 1 minute
and 23 hours 59 minutes.
Upon reaching the end of the running time,
the device switches off automatically and
End appears on the display.
1. Press the button
just the timer setting.
The hour indicator flashes.
2. Press the button +|20/-|22 in order to
set the hours.
3. Press the button
4. Press the button +|20/-|22 in order to
set the minutes.
5. Press the button
the timer.
NOTE: by keeping the buttons +|20 or -|22
pressed, the values toggle until you release the
button.
The selected running time is shown on the
display|10.

6.5 Swivel function

The device has a swivel function.
It causes the device to swivel to and fro, thus
distributing the escaping air more evenly in
the room.
• By pressing button
switch the swivel function on and off.

6.6 Overheating protection

This device possesses overheating protec-
tion for your safety.
If the temperature inside the device becomes
too high, it automatically switches off:
1. Switch the device off by setting the main
switch|9 to 0.
2. Check whether the air inlet or air outlet
are obstructed and eliminate the cause.
If the cause cannot be found and the
|24 in order to ad-
|24.
|24 in order to start
|25, you can
9
GB