Selecting The Temperature; Select Heat Setting; Switching On The Fan - Silvercrest SKD 2300 B2 Operating Instructions Manual

Selecting the temperature

GB
IE

Select heat setting

■
■
■

Switching on the fan

14
NOTE
► The display shows the set target temperature
2
temperature .
20
► The temperature measurement is made by the temperature sensor
may take some time until the whole room has reached this temperature.
♦ Press the button
23
temperature display uses °C or °F.
The selected unit of measurement
♦ Press the "Increase temperature" button,
temperature up to a maximum of 37°C (99°F).
19
The selected target temperature
♦ Press the "Decrease temperature" button,
temperature down to a minimum of 5°C (41°F).
19
The selected target temperature
The heat setting determines how quickly the appliance warms up.
The appliance has three heat settings:
Level 1: 1000 watts
Level 2: 1300 watts
Level 3: 2300 watts
♦ Press the button to select the heat setting
desired heat setting has been set.
The selected heat setting
The appliance has a fan which can be used to distribute heated air throughout
the room more quickly.
♦ Press the fan button
If the fan is running, the "Fan" symbol
NOTE
► If the fan is switched off, the heat is concentrated more around the appli-
ance and is not distributed so quickly around the room.
or 28 to select the unit of measure, to select whether the
is shown on the display
13
15
is shown on the display
19
16
is shown on the display
19
24
10 is shown on the display
14 or to switch the fan on or off.
27
11 appears on the display
and measured actual
19
7
.
2
or , to increase the target
32
.
2
or 29 , to decrease the target
.
2
or repeatedly until the
26
.
2
2
SKD 2300 B2
. It
.