Exchange Gateway - Pilz PSSnet GW1 MOD­-CAN Operating Manual

Operation
7.4 Exchange Gateway
When exchanging the Gateway, the current configuration should be saved first, so that the
configuration can be imported into the new Gateway.
Recommended procedure:
1. Call up the web server and save the configuration.
a Copy these files to a PC using FTP:
2. Switch off the supply voltage.
3. Disconnect all cables from the Gateway.
4. Remove the Gateway from the mounting rail.
5. Install the new Gateway in accordance with the Installation Manual Installation [
6. Incorporate the Gateway into the network Set addresses and transmission rate [
a Make sure that the settings for the IP address, device address and, if necessary,
7. Copy the configuration data to the new Gateway via FTP.
8. Restart the Gateway via the web server.
Operating Manual PSSnet GW1 MOD­CAN
1002693­EN­03
eth_cfg.xml (CANopen configuration),
password.xml (user definition).
transmission rate are exactly the same as they were on the old module.
27].
34].
39