Table of Contents
Advertisement
Commissioning
6.5
Set addresses and transmission rate
6.5.1
Set IP address
The first three bytes of the IP address are: 192.168.0. The last byte of the IP address can
be configured.
The subnet mask is: 255.255.255.0.
The last byte of the IP address is configured using the DIP switches. Value range: 1 ...255.
There are various options for setting the last byte of the Gateway's IP address.
1. Use of the DHCP Server is enabled
DHCP is automatically enabled on a new module. In this case the IP address is taken
from the DHCP Server, if the DIP switch is set to 0. The module waits for approx. 15
seconds to receive an address from a DHCP Server, in which time it uses the default IP
address 192.168.0.1.
a Set the DIP switch to 0.
2. Setting via the DIP switch
The IP address that is set at the DIP switch is used. DHCP is therefore disabled.
a Set the DIP switch to a value between 1 – 254.
3. Enable DHCP via DIP switch
If the DIP switch is set to 255, DHCP is always used, irrespective of the configuration in
the web server.
a Set the DIP switch to 255.
DIP switch
"IP address"
1
2
3
4
5
6
7
8
DIP switch IP address
Operating Manual PSSnet GW1 MODCAN
1002693EN03
INFORMATION
The IP address should only be set when the module is switched off (no
voltage applied).
The settings are only transferred when booting. Any changes made to the
settings during operation will not be transferred.
Meaning
OFF
ON
0
128
D
0
64
D
0
32
D
0
16
D
0
8
D
0
4
D
0
2
D
0
1
D
Example:
IP address 020
D
OFF ON
128
64
32
16
8
4
2
1
Meaning of the switch
setting in the example
0
0
0
16
0
4
0
0
34
Advertisement
Table of Contents
