Table of Contents
Advertisement
COMMISSIONING
Connecting the Power Cord
Ensure that the operating voltage of the mains supply is 230 V before connecting
the machine. The socket must be secured with at least 10 amps. Only connect one
machine per socket.
Do NOT use extension cords, as this can lead to overheating of the cable (fire ha-
zard), or to a loss of voltage.
1
Abb. 1 Turning the system on
•
Open the press.
•
Locate the ON/OFF switch on the back of the housing of your machine
•
Turn the switch to ON.
If your HappyPress 3 switches itself off, restart the machine by pressing the power
switch twice to turn it off and back on again. Proceed by closing and opening your press
once before continuing to print.
Note:
If the power cord is damaged, it must be replaced by the Manufacturer or by a techni-
cal member of staff, to avoid the risk of an electric shock. Use a HSJ Power Cord with
250V - 10AMP for replacement.
2
interrupting the power supply. Push the button until it locks to reconnect the power
supply.
Warning: Failure to observe this information may result in erratic controller func-
tions, inaccurate displays and slow heat-up, the circuit breaker disengaging
Please consider this when replacing.
24
Safety Switch/Fuse
The number on the safety switch indica-
tes the amp at which the safety switch
will release. During a power overload, the
switch will „pop out",
Advertisement
Table of Contents
