Air Temperature (T1) Sensor - Honda Goldwing GL1200L 1985 Manual

Install the sensors in the reverse order of removal.
Remove the white 4P sensor COldo!!ers from the GR/GL
CO!JOIl"lf holder.
Remove the sensor cover. Remove the two bolts and
remove the sensors.
Removalllnstallation
page 7-3).
be handled as a
coil from the frame
Remove the
NOTE: The and GL sensors
matched set Install them in
NOTE: Inspel:::t the
air gap
when the sensors or rotors are
page
1
T1 SENSOR COUPLER
(GREEN)
Disconnect the from the sensor and measure
voltl'icle
between the terminals. should be 4.75-
5.25 V with the switch ON.
Air Temperature (T1)
S e n s o r - - - - - - - - - - - - - - - -
LED Inspection
if there is no check the harness for an
open circuit. Check for continuity between the sensor
ne!gative ( terminal and the No. 3 ECU terminal; bet-
ween the terminal and the NO.1
a
ECU ter-
minal.
With the sensor check for no con-
between the No. 10 ECU terminal and each of the
other terminals and If there is check
the harness for a short circuit.
Check the sensor COllph"r for poor contact at the ter-
minals. If the is check the sensor.
ECl! COUPLER
10..29