Honda Goldwing GL1200L 1985 Manual page 134

Inspection (Solenoid Valve)
Reinstall the and steel ball in the hose
Connect the air hose to the air distributor.
Remove the pressure sensor from the air distributor. At-
tach a hand air pump to the front outlet and apply
pressure.
If pressure does not remain remove the solenoid
valve and the rubber seat at the top of the rod.
maintalinirlO pressure, apply battery bet-
and G ( terminals of the solenoid
If pressure is not relieved the mOillnirinl1
the pressure sensor, install new solenoid valli/ellS).
If pressure remains even when the solenoid valve
is clean the air passage in the air distributor.
RA,nAR!
the above for the rear side
",",nluinn
h"'tif""....'
volitaCle between the Br/Y (
+)
and G (-) terminals
of the valve
C;o'upl'el
vacuum to the air distributor relief port. If vacuum
does not remain remove the solenoid valve and
re[)la()e the rubber seat at the of the rod.
While vacuum, apply between
the Br/W and G terminals of the solenoid
C;OlJpl~~r
Vacuum should be relieved
If vacuum is relieved
ouicklv.
install a new air control nee-
dle in the relief
If the valves do not "click", install new ones.
If vacuum remains even when the the solenoid
valve is clean the air distributor relief
12..19