Honda Goldwing GL1200L 1985 Manual page 23

hrottle Valve
SynC.lt)rCllni~~atlion
- - - - - - - - - - - - - - -......
with the throt-
and left
the idle
the intake and install
adl'ipt1ers and vacuum gauges.
Start the and
tie screw.
Remove the throttle covers,
lower covers and inner covers.
NOTE: Perform this maintenance with the
mal transmission in
its center stand.
Idle 1000
:t
100 rpm
The difference in vacuum
r",,,,rlir,n,,,
should be 40 mm
.6 less.
i:1UIU;:'IIiIU
screw to fix any difference in vacuum
reEldlrlgs between the 1 and and left and 4)
If
anyone is
check for a air leak
Ad.lustml9nt between the front and rear 1 and
or #2 and are not Differences in vacuum
reStOlrlCS between these is due to car-
UUlliU-"11.J
on the throttle valve.
VINYL TUBE
THROTTLE VALVE
remove the air cleaner case
to the T1 senSOL Connect a
and let it idle.
dirt from drawn into the air chamber.
hose to spray
f1AI'hlllrAf(1! nliAl'llrlA!
into the in-
thrt-.il,."h
the wire screen.
NOTES:
• Decarbonize the throttle valve with the vacuum
the lowest last.
• the throttle while the cleaner.
• Use a cleaner a rust inhibitor.
Connect the
vacuum gauge. Start
To clean the throttle
and element holder.
The idle wi!! rise when the throttle valves on both
banks are After the difference in vacuum
has been stabllzed within 40 mm (1.6 or in-
stall the air cleaner case and element Recheck throttle
!'lVflr.hrnni7l'l!tinn
and idle