Error Codes - Hitachi SF-P130TCV Instruction Manual

Error Codes

Error
Description
code
Overloaded
Laundry
Water is not
supplied
Water does not
drain
The tub does not
spin
The lid cannot be
locked
The lid lock
cannot be
released
The spinning
speed does
not reach the
specifi ed value.
n If warning sign such as "F0", "F9"...etc. are shown in the display, stop operating the washer immediately
and contact an authorized service dealer or a service agent for further inspection and/or repairing.
26
Things to check
Check if the laundry is overloaded?
Is the tap open?
Has dirt collected in the water supply inlet
fi lter?
Is the water pipe or water supply hose
frozen?
Has the water supply been disrupted?
The discharge height less than 100 cm.
Is the drain hose blocked?
Is the drain hose twisted, crushed, or frozen?
Is the drain hose connected correctly?
Is the lid open?
Is the laundry all on one side of the tub?
Does the laundry include too many thick
items like cotton blankets or jeans or too
many large items like sheets?
Is the washing machine wobbling, or is the
fl oor under the washing machine slanted?
Are there any unwashable things in the tub?
→Page 8: Preparation of the laundry (sorting
the laundry)
Is the lid closed?
Are there any foreign objects in the lock
switch?
Are there any foreign objects in the lock
switch?
Check if there is too much detergent?
Check if the drain hose is clogged?
Check if the drain hose is installed correctly?
Solution
Decrease the amount of
laundry according to the
instructions on page 16.
Check the tap, water
supply inlet fi lter, water
pipes, and water supply
hose.
Install the drain hose
properly. (see page 29)
Check drain hose, drain
pump and drain outlet.
If C2 still appears after
removing the possible
cause, please contact your
local service center for
repair.
Close the lid.
Add a few more items to
wash. (If there is only one
item in the tub, it is likely to
become unbalanced.)
Check that the lid is
completely closed. Check
that there are no foreign
objects in the lock switch.
Turn the power off and
then on again and wait a
little while. If the lid is still
locked, contact a service
center for repair.
Check the amount of
powder detergent used.
Check the drain hose and
its installation.