Hitachi SF-P130TCV Instruction Manual page 28

How to Install the Washing Machine
Connecting the water supply hose
1 Connect the water supply hose to the Cold and Hot water supply inlet on the washing machine.
2 Screw the union nut to arrow direction to fi rmly attach the water supply opening.
3 Make sure that the union nut between the water supply hose and main unit is tightly screwed.
n The optimum water pressure is 0.03 to 0.8MPa.
n Water leakage may occur if union nut is loosened.
n Unscrew the union nut when dismantling.
Hot water inlet valve
Cold water inlet valve
Hose connector
Rubber seal
n Check that the rubber seal is in the
Hot water supply hose
hose connector.
(Gray hose color)
Cold water supply hose
(White hose color)
Connecting water supply hose to the tap
1 Tighten the water supply hose to water tap.
Water supply hose
n When dismantling, after turn off water tap, press start button and run for 10 seconds for prevent water
from spilling out during dismantling then dismantle the water supply hose.
28