Hitachi SF-P130TCV Instruction Manual page 13

How to Use the Washing Machine
How to use the Tub Clean program
n Use this program separately from other washing programs. (Do not put laundry into the tub.)
1 Press the Power button to turn on the power.
2 Select the Tub Clean program.
n The Tub Clean program can be set to 3 or 11 hours. At fi rst, "11 hours" is set. Press the Program button
again to set "3 hours".
3 Close the lid, and press the Start/Pause button. The washing machine starts pouring water into the
tub. (Close the lid when C3 is displayed)
4 Press the Start/Pause button and open the lid, add tub cleaner to the tub by following the instruction
given on its package. (Liquid peroxide-based bleach is also eff ective as a tub cleaner. Since the
required amount of bleach varies depending on the type, follow the instructions given on its package.)
n Water is added to the maximum level to wash away invisible dirt from both outer and inner tubs.
Then, normal rinse operation will be performed twice to fl ush out any remaining dirt and tub cleaner.
How to use the Delay Timer
1 Press the Power button to turn on the power.
2 Select a program.
3 Press the Delay Timer button and select the time to fi nish washing.
Each press of the button starting from 3 hours to 12 hours later.
4 Press the Start/Pause button.
5 Add detergent and close the lid. The power turns off after a short time.
6 Operations fi nish at the set time.
n The Delay Timer is unavailable for the Blanket and Tub Clean programs.
n To change the setting, press the Power button and do the settings again.
n If there is a power outage while the timer is set, the timer setting is cancelled. If this happens, press the
Power button again and reset the timer.
n To prevent your laundry from wrinkling, take them out from the Washing Machine to dry once the
operation is completed.
13