Table of Contents
Advertisement
Operating the appliance
en
Combination cooking zone
1 = dual-circuit hotplate
2 = single-circuit hotplate
3 = bridge heating element
The single and dual-circuit hotplate can be operated
without the bridge heating element independently of
each other or combined with the bridge heating
element as described in the table.
Combination
Activation
Small roasting
With the
ˆ
zone:
the bridge heating element.
Combination of 1
ˆ
symbol lights up
+ 3
brightly.
Large roasting
Touch the
zone:
Ô
symbol lights up brightly.
Combination of 1
+ 3 + 2
The small roasting zone (1 + 3) and the single-circuit
hotplate (2) can also be operated independently of
each other with different heat settings. Different
temperature ranges are therefore generated at the large
roaster, the teppan yaki or the grill plate, for example:
the small roasting zone can then be used to fry a meal
and the single-circuit hotplate can simultaneously be
used to keep a meal warm.
Suitable cookware is available from the after-
Note:
sales service or our e-Shop.
Residual heat indicator
The hob has a two-stage residual heat indicator for
each hotplate.
If
appears in the display the hob is still hot. It may be
•
used, for example, to keep a small meal warm or to
melt cooking chocolate. As the hotplate cools down
further, the display changes to
until the hotplate has cooled sufficiently.
1Operating the appliance
I n this section, you can find out how to set the
O p e r a t i n g t h e a p p l i a n c e
hotplates. The table shows heat settings and cooking
times for various meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
6
Suitable for
Small roaster
symbol activate
Small teppan yaki
Large roaster
Ô
symbol
Large teppan yaki
Large grill plate
. The display remains lit
œ
Switching on the appliance
Touch the
symbol. A signal sounds. The indicator
#
light above the main switch lights up. The control
displays and the heat setting displays
hob is ready for use.
The two front hotplates are automatically selected. The
‹
heat setting displays light up brightly.
Switching off the appliance
Touch the
symbol until the indicator light above the
#
main switch and the displays go out. All hotplates are
switched off. The residual heat indicator remains on
until the hotplates have cooled down sufficiently.
Notes
The hob will switch itself off automatically once all
■
hotplates have been switched off for a while (10-
60 seconds).
The settings remain stored for 4 seconds after the
■
hob has been switched off. If you switch it on again
during this time, the hob will operate using the
previously stored settings.
Setting a hotplate
Select the desired heat setting on the control panel.
Heat setting 1 = Lowest power
Heat setting 9 = Highest power
Every heat setting has an intermediate setting. It
appears on the display, e.g. as
Selecting the heat setting
The hob must be on.
Touch the
heat setting display to select the
‹
1.
hotplate.
lights up brightly on the heat setting display
‹
Select the required heat setting on the control panel.
2.
The hotplate is switched on.
Changing the heat setting:
Select the hotplate and set the required heat setting on
the control panel.
Switching off the hotplate
Select the hotplate. Set the control panel to 0. After
about 10 seconds, the residual heat indicator appears.
The last selected hotplate remains activated. You
Note:
can set the hotplate without selecting it again.
light up. The
‹
.
.
...
†
Advertisement
Table of Contents
