Table of Contents
Advertisement
Control surfaces
Pressing a symbol activates its corresponding function.
Hotplates
Hotplate
Single hotplate
$
Double hotplate
ð
Triple hotplate
ò
Use only cookware suitable for induction cooking; see the section on suitable cookware.
Residual heat indicator
The hob has a residual heat indicator for each hotplate to show
those which are still hot. Avoid touching a hotplate that displays
this.
Programming the hob
This section will show you how to program the hotplates. The
table contains power levels and cooking times for several
dishes.
Switching the hob on and off
The hob is turned on and off with the main switch.
To switch on: press the
#
main switch lights up. The hob is ready for use.
To switch off: press the
#
main switch disappears. All hotplates are off. The residual heat
indicator stays on until the hotplates have cooled down
completely.
Note: The hob switches off automatically when all the hotplates
are switched off for more than 20 seconds.
Setting the hotplate
The desired power level is set in the programming panel.
Power level 1 = minimum power.
Power level 9 = maximum power.
Each power level has an intermediate setting. This is marked
with a dot.
Turning on and off
Always use cookware of a suitable size.
This zone is switched on automatically when using cookware with a base the
same size as the outer zone.
The hotplate is switched on automatically by using a pan with a base that
matches the size of the outer area (
symbol. The indicator above the
symbol until the indicator above the
Notes
The settings will not change if several symbols are pressed at
■
the same time. This enables the programming zone to be
cleaned when food is spilt.
Always keep the control surfaces dry. Moisture can affect
■
proper functioning.
or
ð
Even when switched off, the
the hotplate remains hot.
If the pan is removed before the hotplate is turned off the
indicators and the selected power level will appear alternately.
Selecting the power level
The range must be switched on.
Press the
symbol of the desired hotplate. The
¤
1.
symbols light up in the display.
Within the next 10 seconds, slide a finger on the
2.
programming panel until the desired power level lights up.
Changing the power level: select the hotplate and set the
3.
desired level using the programming panel.
Switch off the hotplate
Select the hotplate and set it to
The hotplate turns off and the residual heat indicator appears.
Notes
Upon selecting a hotplate the
■
then proceed to be adjusted.
If no pan has been placed on the induction hotplate, the
■
selected power level flashes. After a certain time has
elapsed, the hotplate switches off.
) selected for use.
ò
/
light will remain on as long as
œ
•
‹
‹
in the programming panel.
N
symbol is displayed. It may
œ
/
•
and
N
7
Advertisement
Table of Contents
