Page 1
ET8..LCP1. EN User manual and installation instructions Register your appliance on My Siemens and discover exclusive services and offers. Siemens Home Appliances...
Safety en Further information and explanations are available online: Table of contents 1.2 Intended use Only a licensed professional may connect ap- INFORMATION FOR USE pliances without plugs. Damage caused by in- correct connection is not covered under the Safety .............. 3 warranty. Preventing material damage ...... 4 Only use this appliance: ¡...
en Preventing material damage The cooking surface becomes very hot. If the appliance or the power cord is dam- ▶ Never place flammable objects on the aged, this is dangerous. cooking surface or in its immediate vicinity. ▶ Never operate a damaged appliance. ▶...
Environmental protection and saving energy en 2.1 Overview of the most common damage Damage Cause Measure Scratch Rough pot or Check your cookware. Here you can find the most common types of damage pan bases and tips on how to avoid them. Discol- Unsuitable Only use cleaning...
en Familiarising yourself with your appliance 4 Familiarising yourself with your appliance The instruction manual is the same for various different hobs. You can find the hob dimensions in the overview of models. → Page 2 4.1 Control panel You can use the control panel to configure all functions of your appliance and to obtain information about the operat- ing status.
Page 7
Basic operation en ¡ With multi-circuit hotplates, the heating of the inner Hotplate Activating and deactivating filament circuits and the heating of the activations Dual-circuit ¡ Touch . Second fila- may switch on and off at different times. hotplate, hot- ment circuit is activated. –...
Page 8
en Basic operation Note: The hotplate last selected remains activated. You Stew, soup 3.5-4.5 15-60 can adjust the hotplate without selecting it again. Vegetables, fresh 2.5-3.5 10-20 Vegetables, frozen 3.5-4.5 10-20 5.8 Recommended cooking settings Food in a pressure cooker You can find an overview of different foods with appro- Bring the water to the boil with the lid on.
Page 9
PowerBoost function en 6 PowerBoost function PowerBoost lets you heat up large volumes of water Select the hotplate. even faster than on heat setting 9. Touch . The PowerBoost function is only available on hotplates a The indicator lights up. marked ...
Page 10
en Automatic switch-off Within 10 seconds slide your finger along the con- Tip: The automatic timer is valid for all hotplates. You trol panel until the required cooking time is reached. can reduce or delete the cooking time for individual hotplates. → Page 9 8.2 Kitchen timer You can set a time of up to 99 minutes after which a signal will then sound.
Keep-warm function en 10 Keep-warm function The keep-warm function allows you to melt chocolate 10.2 Switching off the keep-warm function or butter and to keep food or cookware warm. Touch . Select the hotplate. 10.1 Switching on the keep-warm function lights up on the heat setting display. Touch ...
en Cleaning and servicing Touch repeatedly until the required display ap- Dis- Selection pears. play Set the required value on the control panel. Activation of the heating elements – Switched off – Switched on – The last setting before switching off the hotplate.
Troubleshooting en 15 Troubleshooting You can rectify minor faults on your appliance yourself. WARNING ‒ Risk of burns! Read the troubleshooting information before contacting The hotplate heats up but the display does not work. after-sales service. This will avoid unnecessary costs. Switch off the fuse in the fuse box. ▶...
en Disposal Fault Cause and troubleshooting A message with "E" The electronics have detected a fault. appears on the dis- Switch the appliance off and on again. play, e.g. E0111. a If the fault was a one-off, the message disappears. If the message appears again, call the after-sales service. Please specify the exact error message when calling.
Installation instructions en ¡ Ask your specialist retailer for an intermediate floor 18.3 Intermediate floor as an accessory. If the underside of the hob can be touched, an interme- ¡ If you use your own intermediate floor, the minimum diate floor must be fitted. distance to the mains connection of the appliance must be 10 mm.
Page 16
en Installation instructions Use a suitable silicone adhesive to fill the gap between the work surface and the ceramic plate. Before a skin forms on the silicone adhesive, smooth it with a scraper, or your finger, wetted with soapy water. Notes ¡...
Page 20
EN Manufactured by BSH Hausgeräte GmbH under the trademark licence of Siemens AG Valid within Great Britain: Imported to Great Britain by BSH Home Appliances Ltd. Grand Union House Old Wolverton Road Wolverton, Milton Keynes MK12 5PT United Kingdom BSH Hausgeräte GmbH Carl-Wery-Straße 34...