Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - Siemens Et6 Mn21 Series Instruction Manual

Table of Contents

Getting to know your appliance

The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.

The control panel

'LVSOD\ IRU
&RQWUROV IRU
 WLPHU
Æ DXWRPDWLF SURJUDPPHV
– H[WHQGHG FRRNLQJ ]RQH
Controls
When you touch a symbol, the respective function is activated.

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
Extended cooking zone
æ
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the last selected size is automatically selected again

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the
#
indicator above the main switch lights up. The hob is ready for
use.
To switch off: touch the
#
main switch goes out. All hotplates are switched off. The
'LVSOD\ PHQX IRU
WLPHU
IU\LQJ VHWWLQJV
PDLQ VZLWFK
FRQWURO SDQHO SDXVH
Activating and deactivating
Touch the
Touch the
symbol. A signal sounds. The
symbol until the display above the
'LVSOD\V IRU
IU\LQJ VHWWLQJV
VHQVRU IU\LQJ
V\VWHP
PLQ
ORZ
PHG
PD[
PLQ
ORZ
PHG
PD[
6HWWLQJV UDQJH
IRU VHWWLQJ WKH KHDW VHWWLQJ
IRU VHWWLQJ WKH WLPHU
Notes
The settings will remain unchanged if you touch several
symbols at once. This allows you to wipe up spills on the
control panel.
Always keep the controls dry. Moisture reduces their
effectiveness.
ð
symbol
æ
symbol
If
appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to
. The display remains lit until the hotplate has
œ
cooled sufficiently.
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
Note: The hob switches off automatically if all hotplates have
been switched off for more than 20 seconds.
'LVSOD\V IRU
KHDW VHWWLQJ³É
UHVLGXDO KHDW ‡¤
V
&RQWUROV IRU
® KRWSODWH
Í GXDOFLUFXLW
KRWSODWH
6 IU\LQJ VHQVRU
5
Table of Contents
loading
Need help?

Need help?

Do you have a question about the ET6 MN21 Series and is the answer not in the manual?

Table of Contents