Toshiba TCB-TSC640-PY Owner's Manual page 28

Touch Screen Controller

Mode
The mode can be changed via the direct control screen. If you are using a 3 pipe system you will need to
select the auto mode option in the settings - Administrator screen. Mode options that can be set are Auto (If
enabled) Heat, Cool, Dry, and Fan only

Fan
The fan speeds can be adjusted in the direct control screen. The fan speed options that are available are
Auto, low, medium, high.

Louvre
The louvre cannot be set in the direct control screen. The louvre column is for display only to change the
louvre you must use the master control screen,

Set Temperature
The desired set point can be set in the direct control screen. The set point can be in increments of 0.5 or 1. To
set increments enter the settings/ display – operation tab.

Room Temperature
The Room Temperature is displayed on the direct control home screen.

Comms Envelope.
Each time a write command is sent to the touch screen a comms envelope with green sending arrow will be
displayed on the top bar of the touch screen. Once the command has been completed this envelope will
disappear. When the Comms envelope is displayed no commands will be accepted.

Overview screen
If you wish to not send any control commands and just view the status of the indoor units you can use the
overview quick transfer screen button
GPIF control screen
The GPIF control screen allows you to turn on/off up to 4 digital outputs and 2 analogue outputs. The
maximum analogue output value is 10V.
28 (EN)
Owners Manual